22
When mounting on a mortar or concrete surface
• Prepare anchors for 4 mm (3/16 inch) diameter screws for mounting.
A Place the flexible stand on the wall where you plan to mount the flexible stand and mark
the points where you are going to make holes.
B Make holes with an electric drill. Insert anchors (customer-provided) into the holes and
push them inside the holes with a hammer.
• Mortar walls break easily when drilling. Be careful of pieces of mortar which may become
loose and fall.
C Mount the flexible stand using the screws.
Drill for concrete (in case of tile, use a drill for tile)
To Next Page
Loading...
