Panasonic C-D3100ZM-S - Page 20

20
ER Film loading
Use a 35 mm film with a DX code
(ISO 50,100,200,400,800( 1000), 1600, 3200).
The film speed is set automatic.
If the film is not DX coded, the speed is set at ISO 100.
1 Open the back cover in the direction of the arrow.
2 Insert the film cartridge in the direction shown in the figure. Putting
the bottom in first.
3 Pull the film leader across a few centimetres, and set it in the film
guides. Ensure ine film is not slack.
4 Close the back cover until it clicks. The film is then advanced to the
first frame.
If film frame counter “0” blinks when the power is on, open the cover
again and adjust the film correctly,
* Avoid exposure to direct sunlight when loading the film, by moving
into the shade.
Note: Please do not open the back cover after loading the film, If you
do, the film will be exposed resulting in damage. In case of such
accidental exposure, please rewind it by pressing the mid-roll rewind
button. (See the section “Rewinding the film".)