9
Windows 95 Setup
1 Click [Next].
2 Type your name and the name of your company, then click [Next].
3 The "License of Windows 95" should be displayed. Read through this
and then click [Next].
4 The License Agreement should be displayed. Read the Agreement,
check “I accept the agreement”, and click [Next].
If you do not agree, turn the power off and bring the computer to
your nearest Panasonic Service Center.
5 Type in the product number printed on the Certificate of Authenticity;
the Certificate is attached to the "Introducing Microsoft Windows 95
book" included in the "Windows 95 system pack". Click [Next].
6 Click [Next] to configure your computer.
7 Click [Finish] to end the setup.
8 Read the instructions and click [OK]. Windows should restart.
9 At this point, you may have to install a disk to add necessary driver(s)
to your computer.
10 If you want to install your printer driver(s), click [Next]. Follow the
prompts on the screen to specify the printer(s). Otherwise, click [Can-
cel]. (Note: Printer drivers can also be added later.)
11 Set the correct time and click [Close]. (Note: The clock and time
zone are set to values used in Japan. These settings can also be changed
later.) Click [Next] to create system disks.
12 Create back-up disks of the software preinstalled in your computer with
"Microsoft Create System Disks". Be sure to have 37 2HD-type format-
ted floppy disks on hand. Please backup your disks in the following order:
Panasonic Tools Disk 1
Panasonic Tools Disk 2
CardWorks™ INSTALLATION Disk 1
DRIVERS DISK
TranXit Disk 1
TranXit Disk 2
Microsoft Windows 95 Setup disk
13 Follow the instructions that appear on the display.
(for beginners)
MEMO
You can also restart your computer in the MS-DOS
mode by selecting "Restart the computer in the MS-
DOS mode?"
Shutdown
Startup screen
You can turn your computer off by selecting "Shut Down..." from the
"Start" menu.
Startup and Shutdown
To Next Page
Loading...
