Panasonic CF-28 Series - Page 10

First-time Operation
Connect your computer to a power outiet
CAUiTiiON
D-
Be sure the AC adaptor is connected until completing Step 9 on page 12.
Handling the AC adaptor
• Do not twist or pull the AC power cord forcefiilly. Doing so may damage the
connections.
• Use only the specified AC adaptor with your computer. Using an AC adaptor
other than the one supplied might damage the battery and/or the computer,
• When the DC plug is not connected to the computer, disconnect the AC cord
from your AC wall outlet.
O Problems such as sudden voltage drops may arise during periods of thunder and
lightning. Since this could adversely affect your computer, an uninterruptible
power source (UPS) is highly recommended unless the battery pack is installed.
• When closing the cover, first insert the top of the cover.
6
Open the display
(T) Pull the carrying handle forward.
Lift up the latch.
Lift open the display.
Power Indicator @
Turn your computer on
Rotate the power switch clockwise and hold it for approximately one second until the
power indicator turns on before releasing it.
Do not rotate the power switch repeatedly.
Once the computer is powered off, you must wait at least ten seconds before
powering it on again.
NOTE^
The power saving function is factory set, so if there is no input from a key, the
touch pad, the touchscreen or an external mouse (when one is connected) for a
certain interval of time, the power to the LCD and hard disk may be turned off. The
LCD will resume operation when the touch pad, the touchscreen or an external
mouse (when one is connected) is used or a key is pressed.
The power to the LCD may be turned off while Windows is setting up or even when
an application software is being installed. In this case, beca use it is conc eivable that
a selection dialog box will be shown, do not press C Space) or ( Enter ) to attempt
to resume from this condition as doing so may trigger a s election , but instead, press a
key unrelated to the direct triggering of a selection, like (SFD
In addition, when the computer is left alone, it automatically enters the standby*
mode (C? “Standby/Hibemation Functions”). The computer will resume
by rotating the power switch.
* Windows 2000: standby or hibernation