Panasonic CF-28 Series - First-Time Operation

First-time Operation
Read the steps below to help you leam what parts arc included, and to gain an understanding
of some basic computer-related operations.
Cover
Confirm the inclusion of all parts
Make sure the parts shown in the figure have been supplied. If any of these items are
missing or is not working properly, contact Panasonic Technical Support.
^ Write down the Product Key or Product ID
The Product Key or Product ID is necessary during the setup procedure for Windows
after reinstalling. Write down the number shown on the “Certificate of Authenticity"
located on the bottom of the computer in the “Customer’s Record” section on page 2
of this manual.
3 Read the LIMITED USE LICENSE AGREEMENT (o-page 28)
Before removing the seal covering the power switch, read the LIMITED-USE
LICENSE AGREEMENT.
4 Insert the battery pack
(T) Turn your computer over, and slide the latches inward.
@ Lift open the cover holding both sides and remove the cover.
( 3 ) Insert the battery pack into the computer with the label-side up.
• Be sure the battery pack is properly connected to the connector.
• Do not allow the battery connector to touch any portion of the computer.
The computer may not operate properly.
( 4 ) Put the cover back into place holding both sides.
@ Slide the latches outward.
If the cover is not attached properly, the battery may fall out while the com¬
puter is being carried.
When attaching the cover, be careful not to get your fingers and the tab
caught in the cover.
Getting
Started