Panasonic CF-28 Series - Touch Pad

uperaiion
Touch Pad (Basic Operation)
Work Surface
Use the touch pad to move the cursor on the display and perform normal computer operations.
For instructions on how to operate, refer to "Touch Pad (Advanced)".
^note) - V
The toueh pad has been designed to work only when a finger is used. Therefore, do not use
other implement on the touch pad.
rBasic-Qperation-|
Function
Moving the Cursor
Tapping/Clicking
Double-Tapping/
Double-Clicking
Touch Pad Operation
Dragging
Two quick taps, but on the sec¬
ond tap leaving your finger
down (applying pressure) and
moving it on the work surface.
While holding down the but¬
ton, moving your finger on
the work surface.
pHandling-the-Touch-Pad-^
• When using a key combination such as C Fn ) -i- ( F5 ) . do not touch the touch pad. If a key
combination is used while the pad is being touched, the function of the key combination
will not work. In addition, it is possible that control of the cursor will be lost and the cursor
will not show prop er mo vements. In such cases, the computer has to be restarted by using
the keyboard (e.g., [
• Do not place any object on the work surface or press down forcefully with sharp-pointed
objects (e.g., nails), hard objects that can leave marks (e.g., pencils and ball point pen).
• Do not allow things that could dirty the touch pad, such as oil. The cursor may not work
properly in such cases.
• When the touch pad becomes dirty;
Wipe to remove dirty areas by using a dry soft cloth such as gauze or a soft cloth first
applied with detergent diluted with water and then thoroughly wrung.
Do not use benzene, thinner, or disinfectant-type alcohol.
18