Panasonic CF-28 Series - Eject Button

Getting
Started
First-time Operation
Eject Button
Label on the top surface, and insert
the shutter-side headfirst.
(WindowsT2000)
Do not press any key or move the touch pad until [Windows 2000 Professional
^ Setup] is displayed. _ J
(T) At the [Welcome to the Windows 2000 Setup Wizard], then press [Next].
@ After reading the agreement, select [I accept this agreement] or [I don't accept this
agreement], then press [Next].
Xnote>
I If [I don't If [I don't accept this agreement] is selected, the Windows setup will be aborted.
_ y
( 3 ) Select settings for your region, then press [Next].
(2) Enter your name and organization, then press [Next].
-(note) -s
<During the setup procedure only after rcinstaning>
The [Your Product Key] is displayed after you enter your name and organi¬
zation. Input the Product Key written down in the “Customer's Record",
then press [Next]. (Q* page 9 step 2)
V_
Enter your computer name and administrator password, then press [Next].
-;-
Remember this password! If the password is forgotten, Windows 2000 cannot
be operated.
N_ ✓
@ Input the correct date, time and time zone and press [Next].
You can also complete these settings at a later time.
@ Press [Finish]. The computer will restart.
(§) Enter your administrator password, then press [OK].
If the cursor can not be pointed correctly with your finger, perform [Calibration] in
[Start]-[Settings]-[Control Panel]-[Mouse]-[TouchScreen].
9
Create Backup Disks for reinstallation
Prepare 2HD floppy disks and make sure they are not in the write-protected state,
then select [Start] - [Programs] - [Panasonic] - [Create BACKUP DISK] and follow
the on-screen instructions. Place a label identifying the contents on each disk.
AWind5^20Q0X
When [You do not need to make “BACKUP DISK”] is displayed, there is no need to
create a Backup Disk.
• Name of created backup disk
FIRSTAID FD (When the display for creating the UPDATE FD is shown, create
the disk by following the on-sereen instructions.)
12