43
Battery Power
*1
When the AC adaptor is connected.
*2
In high temperature mode, the level that corresponds to an 80% charge for normal temperature
mode is displayed as [100%].
NOTE
This computer prevents overcharging of the battery by recharging only when the
remaining power is less than approx. 95% of capacity after the battery is fully charged.
1 Press
Fn
+
F9
to check the remaining battery power on the screen
(after logging on to Windows)
When the battery pack is inserted in the computer (example)
:normal temperature mode ( page 44)
:high temperature mode ( page 44)
When the battery pack is not inserted in the computer
Blinking orange
*1
Battery cannot be recharged temporarily because the internal
temperature of the battery pack is outside of the acceptable
temperature range for recharging. Once the allowable range
requirement is satisfied, charging begins automatically. Your
computer can be used normally in this state.
Blinking green and orange
alternately
Warming up the system to prevent hard disk drive
malfunctions at low temperature. Leave your computer as is.
Once the allowable range requirement is satisfied, your
computer will start automatically.
Battery Indicator Battery Status
Check the Remaining Battery Power
To Next Page
Loading...
