Panasonic CF-61 Series

37
Error Codes
XXX
Press F1 key to continue.
ERROR CODE
Code DescriptionCode Description
E1 Overcharged
E2 Overdischarged
E3 Cell balance error
E4 Switching error
E5 Temperature is out of range
E6 Exceed maximum charging amount
E7 Exceed maximum charging time
E8 Serial communication error
E9 Overcharged
EA Temperature is out of range
EB No response from battery
EC Changing current does not decrease
ED Abnormal charging current
Should one of the following error codes appear on the status LCD, reconnect the
battery pack and the AC adaptor.
If the error code continues to be displayed, contact a Panasonic Service Center.
Code Description
062 Boot failure--default configuration used Default configuration in use
101 System Board Failure Interrupt controller failure
102 System Board Failure Timer 2 test failure
106 System Board Failure Diskette controller failure
114 Adapter ROM Error Adapter ROM checksum error
151 System Board Failure Real Time Clock failure
161 Bad CMOS Battery Dead battery
162 Configuration Change Has Occurred Configuration error
162 Configuration Error CMOS checksum error
163 Date and Time Incorrect Real Time Clock is not updating
173 Configuration Change Has Occurred ROM configuration changed
177 The security passwords have been corrupted Password is corrupted (CMOS RAM is broken)
201 Memory Size Error Memory size/data error
301 Keyboard Error Keyboard failure
303 Keyboard Error Keyboard controller failure
604 Diskette Drive Error Diskette drive 0 failure
605 Diskette Drive Error Diskette unlocked problem
1780 Hard Disk Error Fixed disk 0 failure
1800 PCI Error No more IRQ available
1801 PCI Error No more room for option ROM
1802 PCI Error No more I/O space available
1803 PCI Error No more memory (above 1 MB) available
1804 PCI Error No more memory (below 1 MB) available
1805 PCI Error Checksum error or 0 size Opt. ROM
8601 Pointing Device Error Pointing device failure
I9990301 Hard disk failure
I9990305 An operating system could not be found
Battery Error Codes
Setup utility ( P.27) is started. Run "Load Default Settings (PnP)".
Next the Setup utility must be run again to input the appropriate operat-
ing environment settings.
These messages are ignored, and then the Operating System is started.
Setup :
Exit :
Follow the menu displayed.
Press
and one of these messages follows.
<For CF-61KXF4BAM/E model only>
Startup Error Codes
During POST (power on self test) the following error codes may be displayed. They
are also displayed if a hardware failure occurs.
<For except CF-61KXF4BAM/E model>