12
Security Measures
CAUTION
Before changing the hard disk, be sure to set the [Hard Disk Lock] of the Setup
Utility to [Disable].
Setting the Hard Disk Lock (enabling, disabling)
1 Run the Setup Utility ( page 39)
2 Using and , select [Security]
3 Using and , select [Hard Disk Lock], then press
Enter
4 To enable the Hard Disk Lock
Select [Enable], then press Enter
At the [Caution], press Enter .
To disable the Hard Disk Lock
Select [Disable], then press Enter
5 Press F10 , then select [Yes]
NOTE
You cannot set the [Hard Disk Lock] without setting the Supervisor Pass-
word. Set the Supervisor Password if you have not done so. ( page 10)
It is possible to set the Hard Disk Lock without setting the User Password,
but we recommend that you set the User Password for security reasons.
NOTE
If [Hard Disk Lock] is not displayed, contact Panasonic Technical Support.
NOTE
In the default setting, [Hard Disk Lock] is set to [Disable].
To Next Page
Loading...
