18
Operation
Starting Up/Shutting Down
The power saving function is factory set, so if there is no input from a key, the touch
pad or an external mouse (when one is connected) for a certain interval of time, the
power to the LCD and hard disk may be turned off. The LCD will resume operation
when the touch pad or an external mouse (when one is connected) is used or a key is
pressed.
The power to the LCD may be turned off even when an application software is being
installed. In this case, because it is conceivable that a selection dialog box will be
shown, do not press Space or Enter to attempt to resume from this condition
as doing so may trigger a selection, but instead, press a key unrelated to the direct
triggering of a selection, like Ctrl .
In addition, when the computer is left alone, it automatically enters the standby or
hibernation mode ( “Standby/Hibernation Functions”). The computer will
resume by sliding the power switch.
Windows XP
When switching to a different user with the Fast User Switching function, it may not
be possible to set the settings of the display. In this case, log off all users, and try the
operation once more. If the problem persists, restart the computer.
NOTE
4
Select your application.
You are able to start working on your computer.
3
Log on to Windows.
Windows XP
After confirming that the hard disk drive indicator ( ) has turned off, select the
user and input the password, then select . Until the correct password is entered, the
computer will not operate.
Windows 2000
After confirming that the hard disk drive indicator ( ) has turned off, input the user
name and password, then select [OK]. Until the correct user name and password are
entered, the computer will not operate.
To Next Page
Loading...
Need help?
General