Panasonic CF-W2 Series

28
Troubleshooting
Reinstalling Software
10 After the reinstallation procedure completes, this screen
should appear.
Remove the Product Recovery DVD-ROM.
Do not interrupt the reinstallation procedure before
completion, for example by turning off the com-
puter or pressing Ctrl + Alt + Del , as this
may prevent Windows from starting up, or may
cause data to be lost so that the reinstallation proce-
dure cannot be executed.
CAUTION
--------------------------------------------------------------------------
[Recovery] is complete.
Windows(R) XP Professional install wizard will start after reboot.
Please Remove the Product Recovery DVD-ROM, and press
Ctrl + Alt + Del(Delete) to reboot.
--------------------------------------------------------------------------
Windows XP
Windows 2000
--------------------------------------------------------------------------
[Recovery] is complete.
Windows(R) 2000 Professional install wizard will start after reboot.
Please Remove the Product Recovery DVD-ROM, and press
Ctrl + Alt + Del(Delete) to reboot.
--------------------------------------------------------------------------
9 At the confirmation message , press Y .
The operation of reinstallation for the hard disk starts au-
tomatically. (The operations take about half an hour.)
<Changing the drive letter>
You can change the drive letter for the DVD-ROM & CD-R/
RW drive or hard disk drive by the following steps.
Drive letters can only be changed when two or more parti-
tions have been created on the hard disk drive. The name
of the C: drive cannot be changed.
We recommend that you make these changes before install-
ing applications.
Windows XP
1 Select [start] - [Control Panel] - [Performance and Mainte-
nance] - [Administrative Tools] - [Computer Management].
2 Select [Disk Management] from [Storage].
3 Right click on the partition of the hard disk or the name of
the DVD-ROM & CD-R/RW drive and select [Change
Drive Letter and Paths...].
4 Select [Change].
5 Select [Assign the following drive letter] and select the new
drive letter, and then select [OK].
6 At the confirmation message, select [Yes].
Windows 2000
1 Select [Start] - [Settings] - [Control Panel] - [Administra-
tive Tools] - [Computer Management].
2 Select [Disk Management] from [Storage].
3 Right click on the partition of the hard disk or the name of
the DVD-ROM & CD-R/RW drive and select [Change
Drive Letter and Path...].
4 Select [Edit].
5 Select [Assign a drive letter] and select the new drive let-
ter, and then select [OK].
6 At the confirmation message, select [Yes].
11 Restart the computer by pressing Ctrl + Alt +
Del and press F2 while [Panasonic] boot screen is
displayed.
The Setup Utility will start up.
If the password has been set, enter the Supervisor Pass-
word.
12 Press F9 .
At the confirmation message, select [Yes] and press
Enter . (The Setup Utility settings will return to their
default values. Even the security settings with the excep-
tion of the password(s) will return to their default values.)
13 Press F10 .
At the confirmation message, select [Yes] and press
Enter .
14 Perform the setup procedure for Windows by following
the instructions on the screen ( page 13).
15 Run the Setup Utility and change the settings where nec-
essary.