27
26
E
N
G
L
I
S
H
CQ-C3303W
Specifications
Note:
¡Specifications and design are subject to modification without notice due to improvements.
¡Some figures and illustrations in this manual may be different from your product.
Power supply : DC 12 V (11 V – 16 V), test
voltage 14.4 V, negative
ground
Current consumption : Less than 2.1 A (CD mode,
0.5 W 4-channels)
Maximum power output : 50 W x 4 (at 1 kHz)
volume control maximum
Power output : 18 W x 4 CH (1 kHz, 1 %, 4 Ω)
Tone adjustment range : Bass: ± 12 dB (at 100 Hz)
Treble: ± 12 dB (at 10 kHz)
Speaker impedance : 4 – 8 Ω
Pre-amp output voltage : 2.5 V (CD mode, 1 kHz, 0 dB)
Pre-amp output
impedance
: 200 Ω
Dimensions (W x H x D) : 178 x 50 x 160 mm
Weight : 1.4 kg
Input impedance : 10 kΩ
Allowable external input : 2.0 V
Connector : 3.5 mm ø Stereo mini-pin
Front AUX input
General
Frequency range : 87.50 MHz – 108.00 MHz
Usable sensitivity : 6 dB/µV (S/N 30 dB)
Frequency response : 30 Hz – 15 kHz (±3 dB)
Alternate channel selectivity : 75 dB
Stereo separation : 35 dB (1 kHz)
Image rejection ratio : 70 dB
IF rejection ratio : 100 dB
Signal to noise ratio : 62 dB
Frequency range : 531 kHz – 1 602 kHz
Usable sensitivity : 28 dB/µV (S/N 20 dB)
Sampling frequency : 8 times oversampling
DA converter : 1 bit DAC system
Pick-up type : Astigma 3-beam
Light source : Semiconductor laser
Wave length : 790 nm
Frequency response : 20 Hz – 20 kHz (±1 dB)
Signal to noise ratio : 96 dB
Total harmonic distortion : 0.01 % (1 kHz)
Wow and flutter : Below measurable limits
Channel separation : 75 dB
CD Player
AM Radio
FM Stereo Radio
To Next Page