q
Radio Mode
Press [SOURCE] to select the radio mode.
Radio Mode Display
w
Band
Press [BAND].
e
Tuning
[[]: Higher frequency
[]]: Lower frequency
Press and hold [[] or []] for more than 0.5
seconds, then release. Seeking will start.
Note:
¡ For tuning in on only stations whose receiving condi-
tions are good in the seeking mode, set LOCAL to ON.
(a Page 30)
¡ For reducing noise when a receiving FM stereo wave is
weak, set FM MONO to ON. (a Page 30)
Display Change
Press [DISP] (Display) to change the display as follows.
3
AM (LW/MW) 3FM (non RDS)
*Adjust the clock when
“
NO CT
”
appears on the screen.
(a Page 9 about Clock setting)
11
1
E
N
G
L
I
S
H
CQ-C5400/C5300/C5100N
10
9
E
N
G
L
I
S
H
CQ-C5400/C5300/C5100N
Auto Preset Memory (APM)
Automatically save stations with good reception in the pre-
set memory.
q Select a band. (a Previous page)
w Press and hold [BAND] (APM: Auto Preset Memory)
for more than 2 seconds.
The 6 stations with good reception will be automatically
saved in the memory under preset number 1 to 6.
Once set, the preset stations are sequentially scanned
for 5 seconds each. (scanning)
Note:
¡ To stop the scanning, press one of the buttons from [1]
to [6].
¡ Only RDS stations will be saved at default setting (AF
ON). To select non RDS stations too, set AF
OFF. (a Page 13)
Manual Preset Memory
Manually save a station in preset memory.
q Select a band and frequency. (a Previous page)
w Press and hold one of the preset buttons from [1] to [6]
until the display blinks once.
Preset number
10
Station Preset
Up to 6 stations can be stored in each of the FM1, FM2, FM3 and AM (LW/MW) band selections.
Caution:
¡ To ensure safety, never attempt to preset stations while you are driving.
Note:
¡ New stations overwrite existing saved stations after following this procedure.
Preset Station Calling
q Select a band. (a Previous page)
w Press one of the preset button from [1] to [6].
Radio
To Next Page
Loading...
