Panasonic CQ-C5301U - User Manual

3
2
E
N
G
L
I
S
H
CQ-C5401U/C5301U
2
1
E
N
G
L
I
S
H
CQ-C5401U/C5301U
Safety Information
Warning
Observe the following warnings when using
this unit.
❑
The driver should neither watch the display nor
operate the system while driving.
Watching the display or operating the system will distract
the driver from looking ahead of the vehicle and can cause
accidents. Always stop the vehicle in a safe location and use
the parking brake before watching the display or operating
the system.
❑
Use the proper power supply.
This product is designed for operation with a negative
grounded 12 V DC battery system. Never operate this prod-
uct with other battery systems, especially a 24 V DC battery
system.
❑
Keep batteries and insulation film out of reach of
infants.
Batteries and insulation film can be ingested, so keep them
out of the reach of infants. If an infant ingests a battery or
insulation film, please seek immediate medical attention.
❑
Protect the Deck Mechanism.
Do not insert any foreign objects into the slot of this unit.
❑
Do not disassemble or modify the unit.
Do not disassemble, modify the unit or attempt to repair the
product yourself. If the product needs to be repaired, con-
sult your dealer or an authorized Panasonic Servicenter.
❑
Do not use the unit when it is out of order.
If the unit is out of order (no power, no sound) or in an
abnormal state (has foreign objects in it, is exposed to
water, is smoking, or smells), turn it off immediately and
consult your dealer.
❑
The remote control unit should not lie about in the
car.
If the remote control unit lies about, it could fall on the floor
while driving, get wedged under the brake pedal, and lead to
a traffic accident.
❑
Refer fuse replacement to qualified service person-
nel.
When the fuse blows out, eliminate the cause and have it
replaced with the fuse prescribed for this unit by a qualified
service engineer. Incorrect replacement of the fuse may lead
to smoke, fire, and damage to the product.
Observe the following warnings when
installing.
❑
Disconnect the lead from the negative (–) battery
terminal before installation.
Wiring and installation with the negative (–) battery terminal
connected may cause electrical shock and injury due to a
short circuit.
Some cars equipped with the electrical safety system have
specific procedures of battery terminal disconnection.
FAILURE TO FOLLOW THE PROCEDURE MAY LEAD TO THE
UNINTENDED ACTIVATION OF THE ELECTRICAL SAFETY
SYSTEM RESULTING IN DAMAGE TO THE VEHICLE AND
PERSONAL INJURY OR DEATH.
❑
Never use safety-related components for installa-
tion, grounding, and other such functions.
Do not use safety-related vehicle components (fuel tank,
brake, suspension, steering wheel, pedals, airbag, etc.) for
wiring or fixing the product or its accessories.
❑
Installing the product on the air bag cover or in a
location where it interferes with airbag operation is
prohibited.
❑
Check for piping, gasoline tank, electric wiring, and
other items before installing the product.
If you need to open a hole in the vehicle chassis to attach or
wire the product, first check where the wire harness, gaso-
line tank, and electric wiring are located. Then open the hole
from outside if possible.
❑
Never install the product in a location where it inter-
feres with your field of vision.
❑
Never have the power cord branched to supply other
equipment with power.
❑
After installation and wiring, you should check the
normal operation of other electrical equipment.
The continuation of their using in abnormal conditions may
cause fire, electrical shock or a traffic accident.
❑
In the case of installation to an airbag-equipping
car, confirm warnings and cautions of the vehicle
manufacturer before installation.
❑
Make sure the leads do not interfere with driving or
getting in and out of the vehicle.
❑
Insulate all exposed wires to prevent short circuit-
ing.
Caution
Observe the following cautions when using this
unit.
❑
Keep the sound volume at an appropriate level.
Keep the volume level low enough to be aware of road and
traffic conditions while driving.
❑
Do not insert or allow your hand or fingers to be
caught in the unit.
To prevent injury, do not get your hand or fingers caught in
moving parts or in the disc slot. Especially watch out for
infants.
❑
This unit is designed for use exclusively in automo-
biles.
❑
Do not operate the unit for a prolonged period with
the engine turned off.
Operating the audio system for a long period of time with the
engine turned off will drain the battery.
❑
Do not expose the unit to direct sunlight or exces-
sive heat.
Otherwise these will raise the interior temperature of the
unit, and it may lead to smoke, fire, or other damage to the
unit.
❑
Do not use the product where it is exposed to water,
moisture, or dust.
Exposure of the unit to water, moisture, or dust may lead to
smoke, fire, or other damage to the unit. Make especially
sure that the unit does not get wet in car washes or on rainy
days.
Observe the following cautions when
installing.
❑
Refer wiring and installation to qualified service
personnel.
Installation of this unit requires special skills and experience.
For maximum safety, have it installed by your dealer.
Panasonic is not liable for any problems resulting from your
own installation of the unit.
❑
Follow the instructions to install and wire the prod-
uct.
Not following the instructions to properly install and wire the
product could cause an accident or fire.
❑
Take care not to damage the leads.
When wiring, take care not to damage the leads. Prevent
them from getting caught in the vehicle chassis, screws, and
moving parts such as seat rails. Do not scratch, pull, bend or
twist the leads. Do not run them near heat sources or place
heavy objects on them. If leads must be run over sharp
metal edges, protect the leads by winding them with vinyl
tape or similar protection.
❑
Use the designated parts and tools for installation.
Use the supplied or designated parts and appropriate tools
to install the product. The use of parts other than those sup-
plied or designated may result in internal damage to the unit.
Faulty installation may lead to an accident, a malfunction or
fire.
❑
Do not block the air vent or the cooling plate of the
unit.
Blocking these parts will cause the interior of the unit to
overheat and will result in fire or other damage.
❑
Do not install the product where it is exposed to
strong vibrations or is unstable.
Avoid slanted or strongly curved surfaces for installation. If
the installation is not stable, the unit may fall down while
driving and this can lead to an accident or injury.
❑
Installation Angle
The product should be installed in a horizontal position with
the front end up at a convenient angle, but not more than
30˚.
The user should bear in mind that in some areas there may
be restrictions on how and where this unit can be installed.
Consult your dealer for further details.
❑
Wear gloves for safety. Make sure that wiring is
completed before installation.
❑
To prevent damage to the unit, do not connect the
power connector until the whole wiring is complet-
ed.
❑
Do not connect more than one speaker to one set of
speaker leads. (except for connecting to a tweeter)
Observe the following cautions when handling
the battery for the remote control unit.
●
Use only specified battery (CR2025).
●
Match the polarity of the battery with the (+) and (–) marks
in the battery case.
●
Replace dead battery as soon as possible.
●
Remove the battery from the remote control unit when not
using it for an extended period of time.
●
Insulate the battery (by placing them in a plastic bag or cov-
ering them with vinyl tape) before disposal or storage.
●
Dispose of the battery according to the local regulations.
●
Do not disassemble, recharge, heat or short the battery. Do
not throw a battery into a fire or water.
In case of battery leakage
●
Thoroughly wipe the battery liquid off the battery case and
insert new battery.
●
If any part of your body or clothing comes into contact with
battery liquid, wash it with plenty of water.
●
If battery liquid comes into contact with your eyes, wash
them with plenty of water and get immediate medical atten-
tion.
This pictograph intends to alert you to the pres-
ence of important operating instructions and
installation instructions. Failure to heed the
instructions may result in severe injury or death.
■
Read the operating instructions for the unit and all other com-
ponents of your car audio system carefully before using the
system. They contain instructions about how to use the sys-
tem in a safe and effective manner. Panasonic assumes no
responsibility for any problems resulting from failure to
observe the instructions given in this manual.
■
This manual uses pictographs to show you how to use the
product safely and to alert you to potential dangers resulting
from improper connections and operations. The meanings of
the pictographs are explained below. It is important that you
fully understand the meanings of the pictographs in order to
use this manual and the system properly.
Warning
This pictograph intends to alert you to the pres-
ence of important operating instructions and
installation instructions. Failure to heed the
instructions may result in injury or material dam-
age.
Caution

Summary

Safety Information

General Safety Pictographs

Explains the meaning of 'Warning' and 'Caution' pictographs used in the manual.

Usage Warnings and Cautions

Important warnings and cautions for operating the unit safely, including driver distraction and proper usage.

Installation Warnings and Cautions

Critical warnings and precautions to follow during product installation to prevent damage or injury.

Mounting and Wiring Cautions

Specific installation advice on mounting stability, wiring, and avoiding interference.

Remote Battery Handling

Safety and Compliance Information

Laser Product Safety Warning

States the product is a Class I Laser Product and warns against improper use or servicing.

General Operation and Sound Settings

Unit Controls Overview

Powering the Unit On;Off

Provides instructions for turning the unit's power on and off using the SRC/PWR button.

Source Selection

Explains how to switch between different audio sources like Radio, CD, XM, and AUX.

Volume and Mute Control

Faceplate and Display Operations

Faceplate Safety Caution

Opening and Closing the Faceplate

Instructions on how to open the faceplate for disc access and close it afterwards.

Adjusting Faceplate Angle (Tilt)

Radio Operation and Presets

Radio Mode and Controls

Introduces the radio mode and its primary controls like SRC, BAND, and display.

Tuning and Band Selection

Details how to tune to radio frequencies and switch between FM/AM bands.

Storing and Recalling Stations

Covers Auto Preset Memory (APM) and Manual Preset Memory for storing and selecting radio stations.

XM Satellite Radio Operations

XM Satellite Radio Setup

Steps for connecting the XM receiver and getting started with XM service activation.

Selecting XM Band and Channel

Instructions on how to select bands (XM1, XM2, XM3) and channels for XM radio.

Display Information and Presets

Category and Direct Channel Access

Disc Playback Preparation

Disc Playback Precautions

Important warnings regarding disc types, handling, and potential damage to the unit.

Disc Insertion Procedure

Step-by-step guide on how to correctly insert a disc into the player.

Disc Ejection Procedure

Instructions on how to safely eject a disc from the player.

CD Player Operations

CD Player Mode and Controls

Overview of the CD player interface and its main controls.

Basic CD Playback Functions

Advanced Playback Modes

MP3;WMA Player Operations

MP3;WMA Player Mode and Controls

Folder and File Navigation

Basic MP3;WMA Playback

Advanced MP3;WMA Playback Modes

CD Changer Operations

CD Changer Mode and Preparation

Disc and Track Navigation

Basic CD Changer Playback

Advanced CD Changer Modes

Audio Settings and Adjustments

Volume Control

Bass and Treble Adjustment

Sound Quality (SQ) Adjustment

Guides on adjusting sound quality characteristics and saving custom SQ presets.

Anti-Theft System Operations

Removing the Face Plate

Step-by-step guide on how to safely remove the unit's face plate.

Installing the Face Plate

Instructions on how to properly reattach the face plate to the unit.

Security Indicator and Alarm

Face Plate Handling Precautions

Troubleshooting Common Issues

General Troubleshooting Warnings

General warnings and precautions to follow before attempting to troubleshoot.

Power and Sound Issues

Addresses common problems related to no power, no sound, or poor sound generation.

Noise and Operation Problems

Solutions for issues involving noise, operational errors, and demonstration screen behavior.

Radio Reception and Presets

XM Radio Channel Issues

Troubleshooting Media and Remote Issues

CD Playback and Disc Issues

Troubleshooting steps for CD playback errors, disc ejection problems, and skipping.

MP3;WMA and CD-R;RW Issues

Remote Control Problems

Understanding Error Display Messages

Explains common error codes displayed by the unit for various functions.

Panasonic CQ-C5301U Specifications

General

Type	CD Receiver
DIN Size	Single DIN
Display	LCD
Bluetooth	No
CD-R Playback	Yes
CD-RW Playback	Yes
HD Radio	No
Satellite Radio	No
AUX Input	Yes
USB Port	No
Detachable Faceplate	Yes
Channels	4
Max Power Output	50 Watts x 4
RMS Power Output	22 Watts x 4
Tuner	AM/FM
Audio Formats Supported	MP3, WMA
Faceplate Security	Detachable
Preamp Outputs	Yes (2-Channel)