Remote
Control Unit
(Includes a battery)
(EUR7641010)
Q'ty: 1
Trim Plate
(YEFC05652)
Q'ty: 1
Accessories
Remote Control Unit
Warning
¡Keep a battery away from children to avoid the risk of
accidents. If an infant ingests a battery, please seek
immediate medical attention.
Caution
¡ Remove and dispose of an old battery immediately.
¡ Do not disassemble, heat or short a battery. Do not
throw a battery into a fire or water.
¡ Follow local regulations when disposing of a battery.
¡Improper use of a battery may cause overheating, an
explosion or ignition, resulting in injury or a fire.
Note:
¡Battery Information:
Battery Type: Panasonic lithium battery (CR2025)
(Included in the remote control)
Battery Life: Approximately 6 months under normal use
(at room temperature)
Remote Control Unit
Instruction kit
Q'ty: 1 set
Installation kit (YEP0FZ5698)
Preparation Before Initial Use
Pull the insulation film out from the
backside of remote control gently.
Battery Replacement
The demonstration message appears for initial
use.
q Set your car’s ignition switch to the ACC or ON position.
The demonstration screen appears.
w Press [DISP].
The demonstration screen is canceled, and no more
appears.
Note:
¡
If you would like to turn on the power and make the
demonstration message appear, press and hold [SRC]
(PWR: Power) for more than 4 seconds.
Main Unit
The 12-hour system is used for the clock.
q Press [SRC](PWR) to turn on the power.
w Press [DISP].
Clock display
e Press and hold [DISP] for more than 2 seconds.
Hour blinks
r Adjust the hour.
[[]: put forward hour.
[]]: put back hour.
Hour entered
t Press [DISP].
Minute blinks
y Adjust the minute.
[[]: put forward minute.
[]]: put back minute.
Minute entered
u Press [DISP].
Completed
Note:
¡“ADJUST” is displayed before adjusting the clock.
¡Press and hold [[] or []] to change numbers rapidly.
Cancellation of demonstration Clock Setting
[SRC]
(PWR: Power)
[DISP] (Display)
[]][[]
(Hour/minute adjustment)
q Remove the battery holder with the
remote control unit placed on a flat
surface.
q Stick your thumbnail into the
groove, and push the holder in the
direction of the arrow, and at the
same time.
w Pull it out in the direction of the
arrow using a tough pointed object.