Panasonic CQ-DP383W

CQ-DP383W CQ-DP383W
E
N
G
L
I
S
H
6
17
E
N
G
L
I
S
H
5
16
Band
Press [BAND].
2
Radio Mode
Press [SRC] (source) to change to the radio
mode.
1
Tuning
[$]: Up
[%]: Down
Press and hold [%] or [$] for more than
0.5 seconds, then release.
Seeking will start.
3
Mono/Local Selection
Press and hold [MONO/LOC] for more than
2 seconds.
Release when at the desired mode.
4
Radio mode display
Note:
≥ Existing saved stations are overwritten with new stations after this procedure above.
1 Select a band. (previous page)
2 Press [1] to [6].
Caution:
≥ To ensure safety, never attempt to preset stations while you are driving.
Press [DISP] (display).
Radio mode display
(default)
Clock display
Band Frequency
FM stereo indicator
Manually save a station in the preset memory.
1 Select a band and frequency. (previous page)
2 Press and hold [1] to [6] for more than
2 seconds to memorize.
≥ The display blinks once, and a receiving sta-
tion is saved in the memory.
Automatically save stations with good reception in
the preset memory.
1 Select a band. (previous page)
2 Press and hold [APM] for more than 2 sec-
onds.
≥ The 6 stations with good reception will be auto-
matically saved in the memory under preset num-
ber 1 to 6.
≥ Once set, the preset stations are sequentially
scanned for 5 seconds each. (scanning)
≥ To stop the scanning, press [1] to [6].
Preset Station Setting
Preset Station Calling
Manual Preset Memory
Auto Preset Memory (APM)
Radio
[1] to [6] (preset station)
Preset number
Display Change
Up to 6 stations each can be saved in the FM1, FM2, FM3 and AM preset station memories.
[SOURCE]
[BAND]
(auto preset
memory)
[%] [$]
(tuning)
[1] to [6]
(preset station)
[DISP] (display)
64
97
5
Car Audio
SOURCE
MUTE
POWER
RAND
VOL
312
DISPBAND
REP
6
5
SET
SEL
#
SCAN
MENU
NUMBER
8
0
LOCAL:
Setting when searching for a station.
LOCAL OFF:Searching even for a relatively
low-intensity radio wave sta-
tion. (default)
LOCAL ON: Searching only for a high-in-
tensity radio wave station.
lights.
[MONO/LOC]
(mono/local selection)
(Press and hold.)
MONO (monaural):
Noise reduction when the receiving sensitivi-
ty becomes low.
MONO OFF: Receiving in stereo. (default)
MONO ON: Receiving in mono and reducing
the noise level.
lights.
2 sec.