Panasonic CQ-RD545LEN - Page 7

Rad id Basics continued
Preset Station Setting
Up to 20 stations can be preset in the station memory as follows;
(Only for RD545/RD535/RD525/RD525G/RD530/RD520G) (Only for RD515)
Manual Station Preset
@ Press BAND to select a desired band.
(@ Use manual or seek tuning to find a station that you want to program
into memory.
@ Press and hold one of the station selector buttons 1 through 5 for
more than 2 seconds until the display blinks.
Repeat the process to set other stations for the FM1 to AM bands.
Preset Channel Indicator
Note: You can change the memory setting by repeating the above proce-
dure.
Tuning in a Preset Station
Press any of the buttons 1 through 5 to tune in the station preset by the
above steps ® to @.
Auto Station Preset
Select a band and press and hold BAND (AUTO PRESET) for more than
2 seconds.
@ The five strongest available stations will be automatically set in memo-
ry on preset buttons 1 through 5.
@ Once set, the preset stations are sequentially scanned for 5 seconds.
e Press the appropriate preset button for the station you want to hear.
To reduce interference during
FM stereo broadcasts
Press and hold PTY (MONO/LOC) for more than 2 seconds to switch
monaural reception in case much interference is present in an FM stereo
signal or to improve the listening quality of weak FM broadcasts.
LOCAL
Lile.ste}
Press and hold PTY (MONO/LOC) to switch the mode in the following
order. Release your finger at the desired mode.
MONO OFF MONO ON MONO ON MONO OFF
LOCOFF % LOCOFF ™® LOCON ®% LOCON
a eee 2
Switching from DX to LOC
Normally, searching stops even at a weak wave station. (DX mode)
To stop searching at a strong wave station only, press and hold PTY
(MONO/LOC) for more than 2 seconds.
(Only for RD545/RD535/RD525/RD525G/RD530/RD520G)
During the AM band reception, press and hold for more than 2 seconds
to switch on or off the LOC mode as follows.
LOC OFF ¢=> LOC ON