Panasonic CQ-RDP112N

6
Power and Audio Controls
[SOURCE] :
Turn the
power on.
● [SOURCE] (Hold down) :
Turn the power off.
¨ : Up
: Down
● Hold down: fast forward
Start the engine first!
[SEL] :
Select a
mode.
1
¨ : Up
: Down
● No operation for 5 sec.
a Return to the regular
mode.
● If the fader is set to
front, the pre-amp out-
put (rear) is decreased.
Note
(–12 to +12 in 3 dB step)
(–12 to +12 in 3 dB step)
(left/right : 1 to 15)
(front/rear : 1 to 15)
Sound quality adjustment
Volume adjustment Power on
[VOL] : Adjust the level.
2
● Power on
●
The volume increases gradually
to the last level if that level was
over 20.
●
When first powered up, a mes-
sage is displayed
● [DISP]: Stop the message.
● [SOURCE](Hold down at power
off) :Turn on the power and dis-
play the message.
Notes
on/
off
MUTE
[MUTE] :Toggle the
Mute on and off.
● Mute the sound.
(Hold down over 2 sec.):
Toggle Loudness on and
off.
● Enhance bass and treble
tones at low volume.
Regular Mode
Volume
Bass
Treble
Balance
Fader