FF
Press and hold for
approximately 10
seconds to show 12-hour
(am/pm) or 24-hour time
indication.
Press to restore the
remote control to
default setting.
Remote control display
Single
Single split system
Multi
Multi split system
MODE
To select operation mode
AUTO - For your convenience
• During operation mode selection the POWER
indicator blinks.
Single
•
Unit selects operation mode every
10 minutes according to setting
temperature and room temperature.
Multi
• Unit selects operation mode every 3
hours according to setting temperature,
outdoor temperature and room
temperature.
HEAT - To enjoy warm air
• Unit takes a while to warm up. The power
indicator blinks during this operation.
COOL - To enjoy cool air
• To reduce power consumption during COOL
mode, use curtains to screen off sunlight and
outdoor heat.
DRY - To dehumidify the environment
• Unit operates at low fan speed to give a gentle
cooling operation.
POWERFUL
To reach temperature quickly
POWERFUL
Single
•
This operation stops automatically after
20 minutes.
Multi
• Press the button again or turn OFF the
unit to stop this operation.
QUIET
To enjoy quiet operation
QUIET
• This operation reduces airfl ow noise.
(Green)
(Orange)
(Orange)
(Orange)
(Orange)
Note
POWERFUL
,
QUIET
• Can be activated in all modes and can be
cancelled by pressing the respective button
again.
• Cannot be selected at the same time.
To adjust horizontal airfl ow direction
• Both upper and lower
horizontal airfl ow
direction louvers are
manually adjustable.
Auto OFF/ON button
Use when remote control is
misplaced or a malfunction occurs.
1. Press the button once to use in
AUTO mode.
2. Press and hold the button until
you hear 1 beep, then release to
use in forced COOL mode.
3. Repeat step 2. Press and hold
the button until you hear 2 beeps,
then release to use in normal
COOL mode.
4. Repeat step 3. Press and hold
the button until you hear 3 beeps,
then release to use in forced
HEAT mode.
• Press the button again to turn off.