2.3. Easy installation
2.3.1. Easy suspension
•
• •
•
A suspension bolt fixing bracket with 4-point support is
attached to the main unit, which increases the space
available for installation.
2.3.2. Two installation methods :
standard and wall
•
• •
•
In addition to the standard (1) ceiling installation, a wall (2)
installation method (using a wall-hanging bracket) is
available for cases where the ceiling is too high for the main
unit to be suspended.
2.4. Piping
2.4.1. 3-direction pipe lead-out
•
• •
•
The refrigerant piping can lead out in one of three directions
(right, rear-right and top-right), and the drain pipe direction
can be selected from four directions (right, rear-right, left
and rear-left).
2.5. Easy maintenance
2.5.1. Long life filter (standard
equipment)
•
• •
•
In general office environments, cleaning (maintenance) is
not required until after approximately 2,500 hours of
operation, thus reducing maintenance work.
•
• •
•
For optimum comfort, it is recommended to clean the air
filter every 1-1/2 months.
2.5.2. Maintenance is possible from
underneath the unit.
•
• •
•
If the bottom panel is detached, the drain pan can then be
removed and installed from underneath the unit, and
inspection and servicing of component such as the control
panel also becomes easier.
2.6. Auto fan mode (indoor unit)
•
• •
•
Auto fan mode is added besides high, medium and low. It
automatically adjusts the fan speed according to the indoor
unit’s temperature.
6
CS-F24DTE5 CU-L24DBE5 / CS-F28DTE5 CU-L28DBE5
To Next Page
Loading...
