4
ENGLISH
NAME OF EACH PART
■ Remote Control
1 Signal Transmitter
2 Operation Display
3 OFF/ON Button
4 Room Temperature Setting Button
5 Operation Mode Selection Button
6 Timer Set Button
7 Fan Speed Selection Button
8 Air Flow Direction Button
9 Reset Point
(Press with fine-tipped object to clear the memory)
● Remote Control Signal.
• Make sure it is not obstructed.
• Maximum distance : 10 m.
• Signal received sound.
One short beep or one long beep.
● Notes for Remote Control.
• Do not throw or drop.
• Do not get it wet.
• Certain type of fluorescent lamps may affect
signal reception. Consult your dealer.
1
2
4
3
5
8
7
9
6
● How to Insert the Batteries
1 Slide down the remote control cover completely
2 Insert the batteries
– Be sure the direction is correct.
● About the batteries
• Can be used for approximately one year.
● Observe the following when replacing the
batteries
• Replace with new batteries of the same type.
• Do not use rechargeable batteries (Ni-Cd).
• Remove the batteries if the unit is not going to
be used for a long period.
PREPARATION BEFORE OPERATION
■ Indoor Unit
1 Connect the power supply cord to an independent
power supply
2 Open the front panel
3 Insert the air filters
4 Close the front panel
2
1
4
3
2
1
F564222 01-09-EN 9/12/03, 5:28 PM4
To Next Page
Loading...
Need help?
General
