Panasonic CS-RE9MKR - Remote Control Operation; Turn On or Off the Unit; Set Temperature; Select Operation Mode

17
ENGLISH
5
ENGLISH
REMOTE CONTROL
CHECK
ERROR RESE
T RESET
SELECT
SET/CANCEL
AIR CONDITIONER
QUIET
POWERFUL
/
A
B
Press the remote control’s button
1
TO TURN ON OR OFF THE UNIT
• Please be aware of the OFF indication on the remote
control display to prevent the unit from starting/stopping
improperly.
2
TO SET TEMPERATURE
• Selection range: 16°C ~ 30°C.
• Operating the unit within the recommended temperature
could induce energy saving.
HEAT mode : 20°C ~ 24°C.
COOL mode : 26°C ~ 28°C.
DRY mode : 1°C ~ 2°C lower than room temperature.
3
TO SELECT OPERATION MODE
AUTO mode - For your convenience
• During operation mode selection the power indicator blinks.
• During Automatic Operation, the operation mode will
be selected automatically in accordance with the room
temperature, outdoor air temperature and set temperature
of remote control.
HEAT mode - To enjoy warm air
• In heat mode, it may take a while for the unit to warm up.
The POWER indicator blinks during preheating.
COOL mode - To enjoy cool air
• Use curtains to screen off sunlight and outdoor heat to
reduce power consumption during cool mode.
DRY mode - To dehumidify the environment
• Unit operates at low fan speed to give a gentle cooling
operation.
4
TO SELECT FAN SPEED (5 OPTIONS)
FAN SPEED
• For AUTO, the indoor fan speed is automatically adjusted
according to the operation mode.
Maximum distances: 8m
Remote Control display
5
TO ADJUST AIRFLOW DIRECTION
(5 OPTIONS)
AIR SWING
• Keeps the room ventilated.
• In COOL mode, if AUTO is set, the louver swing up/down
automatically.
• In HEAT mode, if AUTO is set, the horizontal louver x at
predetermined position.
6
TO ACHIEVE TEMPERATURE QUICKLY
• This setting enables the desired set temperature to be
reached quickly.
7
TO ENJOY QUIET ENVIRONMENT
• This setting provides a quiet environment by reducing the
airow noise.
• POWERFUL AND QUIET operations can not be activated
at the same time.
8
PRESS TO RESTORE THE REMOTE CONTROL’S
DEFAULT SETTING
9
NOT USED IN NORMAL OPERATIONS
INDICATOR
(GREEN)
(ORANGE)
(GREEN)
(RED)
1
5
3
6
8
4
7
9
2
F568295_EN_CS4.indd 17 2011-8-4 17:47:50