67
12.11 Patrol Operation
• To monitor air dirtiness level by using Patrol sensor and to maintain air freshness by activates e-ion operation
• Patrol operation starts condition
o When the unit operation is started with “OFF/ON” button
o When the unit stops, “Patrol” operation is selected, Patrol individual operation will start.
o During cooling only operation, “Patrol” operation is selected.
• Patrol operation stops condition (when any of the following condition is fulfilled):
o When “OFF/ON” button is selected.
o During any operation with Patrol, “PATROL/e-ion” button is pressed.
o When OFF Timer activates.
• To disable the Patrol Operation during unit starts (default) with “OFF/ON” button
o Press “Set” button continuously for 15 seconds by using pointer during Air Conditioner is OFF condition to
enter internal setting mode.
o Press “Timer Decrement" button to select “Pt dFLt”.
o Press “Timer Set” button to toggle Patrol operation default OFF/ON.
Long "beep": Turn OFF Patrol operation default.
Short "beep": Turn ON Patrol operation default.
SET
SET
Transmit Patrol default OFF/ON code
(Buzzer: OFF:Long Beep, ON:Short Beep)
Press continously for 15s
SET
Transmit Patrol demo code
(Buzzer: OFF:Long Beep, ON:Short Beep)
SET
Transmit ECO demo code
(Buzzer: OFF:Long Beep, ON:Short Beep)
SET
Transmit check code
(Buzzer:Short Beep)
To Next Page
Loading...
