123
5 Customization list table:
Note: The functions described in the table may not be applicable to the model and may subject to change without
further notice.
Customization
Options Remark
No Name
Customer
Zone
1 Remote control number selection A, B, C, D
2 Solar radiation sensitivity level adjustment 1, 2, 3, 4, 5
3
[iAUTO-X/iAUTO/iCOMF, Cool & Dry] mode set temperature [Low2]
selection
16°C ~ [High2]
4
[iAUTO-X/iAUTO/iCOMF, Cool & Dry] mode set temperature [High2]
selection
[Low2] ~ 30°C
5 Heat mode set temperature Low1 selection 16°C ~ [High1]
6 Heat mode set temperature High1 selection [Low1] ~ 30°C
7 Filter cleaning selection
00 – Disable
01 – Enable
8 nanoe/nanoe-G default ON selection
00 – Disable
01 – Enable
9 Dust sensor monitoring & LED selection
00 – Disable
01 – Enable
10 Auto restart selection
00 – Disable
01 – Enable
11 Dust sensor sensitivity level adjustment 1, 2, 3
12 Auto mode set temperature Low3 selection 16°C ~ [High3]
13 Auto mode set temperature High3 selection [Low3] ~ 30°C
14 ~ 49 Reserve
Service
Zone
50 ECO demo ON None (No display)
51 Light sensor check None (No display)
52 nanoe-G / ECO sensor check None (No display)
53 DOA check None (No display)
54 Odor cut control selection
00 – Disable
01 – Enable
55 Frequency tolerance selection
03 – ±3Hz
07 – ±7Hz
56 Fixed fan speed selection during heat mode compressor OFF
00 – Disable
01 – Enable
57 nanoe check None (No display)
58 Heat mode thermo shift adjustment -3°C ~ 3°C
59 Others (Cool & Dry) mode thermo shift adjustment -3°C ~ 3°C
60 Deice start determination judgment temperature switching
00 – No
01 – Yes
61 Cool mode disable selection
00 – No
01 – Yes
62 Heat mode disable selection
00 – No
01 – Yes
63 Base pan heater selection
A – Base pan A
b – Base pan B
64 Disable fan speed reduction during cool mode thermo-Off
00 – No
01 – Yes
65 LED smart OFF selection
00 – Disable
01 – Enable
66 nanoe-G ON/OFF duration selection
01 – Pattern 1
02 – Pattern 2
03 – Pattern 3
04 – Pattern 4
67 Operation OFF deice function selection
00 – Disable
01 – Enable
68 Compressor frequency change speed selection
01 – Pattern 1
02 – Pattern 2
03 – Pattern 3
69 Up/Down air swing upper limit restriction selection
00 – Disable
01 – Enable
70 Failure diagnosis mode disable None (No display)
71 Compressor Fhmax setting selection
01 – Offset 1
02 – Offset 2
03 – Offset 3
72 ~ 99 Reserve
To Next Page
Loading...
