rnstallation
INSTALLATION
I'elevision Location
This unit is intended to be used with an optional stand or entertainment
center. Consult your dealer for available options.
[3 Avoid excessive sunlight or bright lights, including reflections.
C3 Keep away from excessive heat or moisture. Inadequate ventilation
may cause internal component failure.
O Fluorescent lighting may reduce Remote Control transmitting range.
O Avoid magnetic equipment, including motors, fans, or external speakers.
Optional Cable Connections
Shielded audio and video cables should be used between components. For
best resulLs:
[3 Use 75-ohm coaxial shielded cables.
O Use appropriate input and output connectors that match your
component connectors.
O Avoid long cables to minimize interference.
_,C Power Supply Cord
CAUTION: TO PREVENT ELECTRIC SHOCK,
MATCH WIDE BLADE OF PLUG TO WIDE SLOT OF
AC OUTLET AND FULLY INSERT. DO NOT USE A
Polarized plug
PLUG WITH A RECEPTACLE OR OTHER OUTLET
UNLESS THE BLADE CAN BE FULLY INSERTED TO
PREVENT BLADE EXPOSURE.
3able / Antenna
For proper reception, either a cable or antenna connection is required.
Cable Connection
Connect the cable supplied by your local IncomlngCabletrom
cable company. Cable Company
Note: A cable converter box may be required for
proper reception. Check with your local _
cable company for compatibility 75 Ohm VHF/UHF
requirements, on back ofTV
Antenna Connection
For proper reception of VHF/UHF channels, an external
antenna is required. For best reception an outdoor antenna
is recommended.
Antenna Mode must be set to TV.
Cable Mode is preset at the factory.
Antenna users must change to TV Mode
in the SETUP Menu.
Note:
Incoming Cable from
Home Antenna
[]
To Next Page
Loading...
