11.2. Accessories
11.3. Select The Best Location
11.4. Window requirements
•
Hot sun rays hitting the outside surface of the cabinet will
create considerable heat load. If the outside of the cabinet
is exposed to direct sunlight, consider building an awning to
shade the cabinet while providing ample area for the heated
air to be exhausted from the condenser (both sides) and the
top.
This unit is designed for installation in standard double hung
windows.
NOTE
The unit may also be installed “through the wall“. You should,
however, observe standard carpentry practices and frame the
opening without violating local ordinances.
11.5. Installation procedures
1. Remove the rear cabinet screws and save for later use.
2. Slide the chassis out from the cabinet.
11 Installation Instructions
11.1. Installation Box Contents
18
CW-XC100VK / CW-XC120VK
To Next Page
Loading...
