Panasonic Cyclonic Iverter NN-SN97JS - Timer and Delayed Start; Kitchen Timer and Standing Time; Delayed Start Programming

13
Operation (continued)
Setting the Timer Setting a Standing Time Setting a Delayed
Start
1
This feature allows you to
program the oven as a kitchen
timer. Press Timer/Clock (Less)
once.
2
Set desired amount of time
using Number pads (up to 99
minutes, 99 seconds).
3
Press Start. The timer will count
down without cooking and
beep five times when done.
Caution: If oven lamp is lit
while using the timer feature
with door closed, the oven is
NOT set properly; STOP OVEN
IMMEDIATELY and re-read
instructions.
1
Some recipes call for a standing
time after cooking. Press Power
Level until the desired power
level appears in the display.
2
Set Cooking Time using the
Number pads (see previous
page for maximum times).
3
This feature allows you to
program the oven as a kitchen
timer. Press Timer/Clock (Less)
once.
4
Set desired amount of stand
time using Number pads (up
to 99 minutes, 99 seconds).
3
Press Start. The timer will start
and then beep twice at the end
of cooking time (the beginning
of standing time). Five beeps
will sound when standing time
is done.
1
The start time can be delayed
to start cooking at a later time.
To do this, first press Timer/
Clock (Less) once.
2
Enter the desired delay time
(up to 99 minutes, 99 seconds)
using the Number pads.
3
Press Power Level until the
desired power level appears in
the display.
Continued on the
Next Page
F0003BY70AP_02_20171208.indd 13 2017/12/8 15:02:27