Panasonic CZ-64ESMC2 - Address and Switch Settings; Address Switch Configuration; Accessing the Control Unit PCB

9
EN
How to start collective operation

To start collective operation (ALL or ZONE)
Stop
Power Turn the power supply switch on 5 hours or more before starting operation.
1
Press the SELECT button and select ALL or ZONE.
In case of ZONE collective operation.
2
Select the ZONE No. to be operated by pressing ZONE button.
3
Press the ON button.
4
Set the operation mode by pressing the MODE button.
5
Set the desired temperature by pressing one of the temperature setting buttons .
6
Set the desired fan speed by pressing the FAN SPEED button.
7
Select the control mode.
Stop
Confi rming the ZONE No. to be selected or ALL indication, press the OFF button.
In the ALL or ZONE mode, no fl ap setting can be performed. If necessary, you should select
the GROUP mode and use the FLAP button.
NOTE
CZ-64ESMC2all.indb9CZ-64ESMC2all.indb9 2011/09/0714:37:502011/09/0714:37:50