Panasonic CZ-64ESMC2 - (C) Automatic Zone Registration Using the System Controller

17
EN
(c) Automatic zone registration using the system controller
(1) Press the
and buttons at the same time for more than 4
seconds.
and CODE No. C1 will fl ash.
(2) Select CODE. No. C2 by pressing
and ( ) button and
press the button.
C2 changes from fl ashing to ON state and automatic zone
registration will start.
(3) Registered GROUP No. will be disappeared all.
(4) Central address will be assigned from small indoor unit address to
large one in numerical order automatically.
Finishing automatic zone registration,
changes from fl ashing
to OFF.
(5) If the error is happened, the “CHECK” starts fl ashing and zone
registration fi nishes at this time. Press the
button.
(6) Finally, complete automatic zone registration mode by pressing the
button.
fl ashes for a few minutes, then OFF.
Fig. 12
CZ-64ESMC2eng.indd17CZ-64ESMC2eng.indd17 2010/12/2416:58:362010/12/2416:58:36