8
(EN)
(mm)
2323
83.5
5-5x9
120
120
16
Embedded type
Preparation: Make 2 holes for screws using a driver.
1
3
2
Connect the remote control
wiring
Mount the top case.
Align the claws of the
top case and then
align the claws of the
bottom case.
Avoid the
wire being
caught.
Claw (2 places)
Screw
(Supplied)
Hole for screw
Claw (2 places)
Mount the bottom case to the wall.
Pass the wire through the hole in the centre
of the bottom case.
Remote controller terminal board
Remove the coating. Approx. 6 mm
Make sure the wiring connection is
in the correct direction.
Bottom case
(Back side)
Top case
(Back side)
Dimensions
www.ampair.co.uk | sales@ampair.co.uk
To Next Page
Loading...
