Panasonic CZ-RTC5A

6
1
Start operation.
Press
.
(The operation indicator illuminates.)
2
Select the item to set.
Press ◄ ►.
3
Change the setting.
Press ▲▼ → .
(The cursor disappears.)
Basic Operations
 Operation mode (e.g. Cool, Heat, etc.)
Press ◄.
* Auto:
The mode is
automatically
switched to
Cool or Heat to
achieve the set
temperature.
Heat
Dry
Cool
Fan
Auto
Note
 Operation modes that cannot be set are not displayed.
 The swing and airfl ow direction on the remote control is not synchronised with the
fl ap movement.
 The fl ap display diff ers from the actual fl ap angle.
 Pressing
after recovery from mains power failure will resume operation with
the contents before mains power failure has occurred.
 If no operation is performed for a certain period of time, the backlight turns off to
save electricity. (Press any button for illumination.)
 The energy saving operation restricts the maximum current value, resulting in
decreased cooling/heating performance.
(If the current of outdoor units does not reach the peak due to low load operation,
the current value is not restricted.)
 For models that cannot change the airfl ow direction, the airfl ow direction is not displayed.
 The fan speed and airfl ow direction in cooling/drying operation can be adjusted with 3
levels if controlling using one remote controller while assigning a indoor unit (e.g. ceiling-
hung type) which has a 3-level adjustment of fan speed and airfl ow direction in cooling /
drying operation as main unit, and assigning a 4-way ceiling cassette type as sub unit.
ㆇォ ࡕ࡯࠼ ⸳ቯ󰶘ᐲ

㧔ᧁ㧕
಄ᚱ
28
࠽ࡁࠗ࡯
ળ⼏ቶ
㘑ㅦ
㘑ะ
業務用リモコンCZ-RTC5A簡単ガイド.indd6業務用リモコンCZ-RTC5A簡単ガイド.indd6 2016/08/1914:54:022016/08/1914:54:02