90
VQT0N05
When condensation has taken place
≥ Turn this unit off and leave this unit in this condition for about 1 hour.
When this unit becomes close to the ambient temperature, the
condensation disappears naturally.
≥ When you move this unit from a cold place to a hot place, put the
camera into plastic bag and then take it out after the temperature of
this unit becomes close to the ambient temperature to avoid
condensation.
≥ In a place with drastic temperature changes, condensation may form
on the LCD Monitor. Wipe it with a soft, dry cloth.
≥ Do not press the LCD Monitor strongly. It may cause uneven colours
on the LCD Monitor or a malfunction of the LCD Monitor. Or, do not
touch a hard object to the LCD Monitor. It causes scratches on the
surface of the LCD Monitor.
≥ When the Lens is aimed to contrasty subject, the picture may look
uneven or after images may appear on the LCD Monitor. This is not a
malfunction.
≥ If the SD Multi Camera is extremely cold when you turn this unit on,
the image on the LCD Monitor is slightly darker than usual. However,
as the internal temperature increases, it goes back to the normal
brightness.
LCD Monitor
Extremely high precision technology is employed to produce the
LCD Monitor screen featuring a total of approximately 61,600 pixels.
The result is more than 99.99% effective pixels with a mere 0.01% of
the pixels inactive or always lit. However, this is not a malfunction
and does not affect the recorded picture.
Cautions for Use (continued)
VQT0N05Eng.book 90 ページ ２００４年１１月２２日 月曜日 午前１０時１２分
To Next Page
Loading...
