Highqualitydigital-to-digitalcopyingcan
beaccomplishedifboth Palmcorders
incorporate the DV Input/Output (i.LINK)
Connector (DV interface cable (i.LINK) is
not supplied).
Source (Playing) J
Palmcorder J
•Before you begin
Connect both Palmcorders to their !
i power sources, j
Connect the two Palmcorders using the!
DV interface cable (i.LINK) i
(4-pin to 4-pin). J
• Turn both Palmcorders ON. J
Insert a pre-recorded tape into the
source (playing) Palmcorder, and set
POWER to VCR.
Insert a blank tape with the record
Input/Output tab closed into the target (recording)
(i.LINK) Connector Palmcorder and set POWER to MCR.
Cable (LLINK)
(optional)
3, 4, 5
PAUSE
3, 4PLAY
Recording _ Press I_ (PLAY) on the source
Pa recorder Palmcorder. When the tape reaches
the point you want to start dubbing,
press II (PAUSE).
Hold down REC and press I_ (PLAY)
on the target (recording) Palmcorder.
Press II (PAUSE) to pause the tape at
the starting point of the dub.
5
6
Simultaneously, press I I (PAUSE) on
both units to begin dubbing.
Press • (STOP) on the recording
unit, and then press • (STOP) on the
playing unit to end dubbing.
6STOP
• When two Palmcorders are connected
using the DV interface cable (i.LINK) (not
supplied), a Video Editing Controller
cannot be used.
• Do not connect both an A/V CabJe and a
DV Interface Cable (i.LINK).
_bUoCAUTION:
nauthorized exchanging and/or I
pying of copyrighted recordings may I
copyright infringement.
41
To Next Page
Loading...
