Available ash s
ettings
by recording mode
The available ash settings depend on the
recording mode.
(○ : Available, — : Not available, ◎ : Initial
setting)
2 When AUTO is selected, depending
on the type of subject or brightness,
ash is set i AUTO [ ], i AUTO/
Red-eye reduction [ ], or i Slow
sync./Red-eye reduction [ ].
■ The ash setting may change when you
change the recording mode. Change the
ash setting again if necessary.
The ash setting is memorized even if
the camera is turned off.However, the
ash setting is reset to the initial setting
when the advanced scene mode or
scene mode is changed.
The available ash range to take pictures
ISO sensitivity
Available ash range
AUTO 50 cm to 6.8 m (Wide)
1.0 m to 3.8 m (Tele)
ISO100 50 cm to 2.1 m (Wide)
1.0 m to 1.2 m (Tele)
ISO200 50 cm to 3.0 m (Wide)
1.0 m to 1.7 m (Tele)
ISO400 60 cm to 4.3 m (Wide)
1.0 m to 2.4 m (Tele)
ISO800 80 cm to 6.0 m (Wide)
1.0 m to 3.4 m (Tele)
ISO1600 1.15 m to 8.6 m (Wide)
1.0 m to 4.8 m (Tele)
The available focus range differs
depending on the recording mode.
When you use the ash when you
have set ISO sensitivity to [AUTO], ISO
sensitivity automatically becomes a
maximum of [ISO1000].
The edges of the picture may appear
dark if you shoot a very close subject with
the ash while the zoom lever is close to
the W side. Zoom in slightly if this occurs.
Available ash range varies depending
on ISO sensitivity in [HIGH SENS.].
W: approximately 1.15 m to 17.2 m
T: approximately 1.0 m to 9.6 m
•
•
■
•
•
•
•
–
–
To Next Page
Loading...
