29
Notes when attaching the tray:
1. Be sure to leave the OPU at the inner limited posts.
2. Push Slide cam to the left side slightly, and make sure
the tray band is between the two posts of Slide cam
when attaching the tray.
9.2.2. Pulley Gear, Belt
1. Perform the step “ Tray ”.
2. Push the Post to the direction of arrow by using the
slotted screwdriver.
3. Remove the Pulley Gear and Belt.
9.2.3. Slide Cam
1. Perform the step “ Pulley Gear, Belt ”.
2. Remove the OPU FFC sheet from the mecha chassis.
To Next Page
Loading...
