28
9.1.7. BD Drive
1. Remove the OPU FFC, and isolate it with an
ESD prevention bag (RPFC0114) to prevent the laser
diode from the ESD damage. Do not touch the OPU FFC
conductive surface.
2. Remove the 3 FFCs.
3. Remove the 4 Screws (A ) to remove BD Drive.
9.1.8. Digital P.C.B.
1. Remove the 2 Screws (A).
9.1.9. Power SW P.C.B.
1. Remove the Screw (A).
9.2. BD Drive
9.2.1. Tray
1. Insert the Paper clips, etc. into the hole of the bottom
side, and slide it to the direction of arrow until it can be.
2. Pull the Tray to the direction of arrow until it can be.
3. Push the two posts in front of the mecha chassis to both
sides of the drive to unlock the tray, and push it outward
simultaneously.
To Next Page
Loading...
