Panasonic DMP-BD90

- 22 -
Settings
Reference
Troubleshooting guide
Before requesting service, please perform the
following steps.
∫ Unit does not respond to remote
control or unit’s buttons.
Disconnect AC adaptor, wait 1 minute, then
reconnect AC adaptor.
The following do not indicate a problem with
this unit:
– Regular disc rotating sounds.
– Image disturbance during search.
∫ Cannot eject disc.
1 While the unit is on
Press and hold
[] on the main unit and the
[0] on the remote control at the same time for
more than 5 seconds.
– POWER LED starts to flash, and “00 RET”
is displayed on the screen.
2 Press [1] (right) repeatedly on the remote
control until “06 FTO” is displayed on the
screen.
3 Press [OK].
To return to the factory defaults.
¾ Select “Yes” in “Restore Default Settings” in
the Setup menu. (> 21)
To return all settings to the factory preset.
¾ Reset the unit as follows:
1 While the unit is on
Press and hold
[] on the main unit and the
[0] on the remote control at the same time for
more than 5 seconds.
– POWER LED starts to flash, and “00 RET”
is displayed on the screen.
2 Press [1] (right) repeatedly on the remote
control until “08 FIN” is displayed on the
screen.
3 Press and hold [OK] for more than 5 seconds.
The remote control does not work properly.
¾ Change the batteries in the remote control.
(> 5)
Other Panasonic products respond to this
remote control.
¾ Change the remote control code of other
Panasonic products to other than code 1.
The TV tuner mode is not displayed when the
TV is turned on.
¾ This phenomenon may occur, depending on
the TV setting, when “Quick Start” is set to
“On”.
¾ Depending on the TV, this phenomenon may
be prevented by reconnecting the HDMI cable
to a different HDMI input terminal or by
changing the HDMI auto connection setting.
This unit is turned off automatically.
¾ To save on electricity, this unit is turned off
automatically if there is no button operation
for about 20 minutes when not playing back
(such as when paused or displaying the
menu, displaying still pictures, etc.).
Do you have the latest firmware installed?
Panasonic is constantly improving the unit’s
firmware to ensure that our customers are
enjoying the latest technology. (> 11)
4
Make the following checks and visit our
website for more information.
http://shop.panasonic.com/support
4
Or visit our website to find a service center.
You can find a service center near you easily
on our website.
Other support information:
“Limited Warranty” ( > 29).
General operation
DMP-BD90_TQBS0470_eng.book 22 ページ ２０２２年１月２０日 木曜日 午後２時５６分