Panasonic DMP-BDT310 - Wireless LAN Connection Precautions

Precautions
of
Wireless
LAN connection
The
following
limits are
in
place regarding the usage
of
this unit or
Wireless LAN adaptor.
You
must be aware
of
these limits before using
these devices.
Panasonic
will
in no way
be
responsible for any incidental damage which
may
arise
due
to a failure
to
obey these limits,
or
to
any condition
of
use or
disuse
of
these devices.
•
Data
transmitted
and
received
over
radio
waves
may
be
intercepted
and
monitored.
•
This
unit
or
Wireless
LAN
adaptor
contain
delicate
electronic
components.
Please use these devices in the manner
in
which it was intended and
follow
the
following
points:
- Do not expose these devices to high temperatures or direct sunlight.
- Do not bend,
or
subject these devices to strong impacts.
- Keep these devices away from moisture.
- Do not disassemble or alter the device in any way.
I
BOT31
0
II
BDT215
II
BDT210
I
THE FOLLOWING APPLIES IN THE U.S.A. AND CANADA
This device complies with Part 15
of
FCC Rules and RSS-Gen of
IC
Rules.
Operation is subject to the following
two conditions:
(1) This device may not cause interference, and (2) this device must
accept any interference,
including interference that may cause undesired
operation
of
this device.
Contains FCC
10:
VPY-LBSJ
Contains
IC:772C-LBSJ
This transmitter must not be co-located
or
operated
in
conjunction with
any other antenna or transmitter.
This product is restricted to indoor use due to its operation
in
the 5.15 to
5.25 GHz frequency range.
FCC and
IC
require this product to be used indoors for the frequency
range 5.15 to 5.25 GHz to reduce the potential for harmful interference
to
co-channel Mobile Satellite
systems. High power radars are
allocated as
primary users
of
the 5.25 to 5.35 GHz and 5.65 to 5.85 GHz bands.
These radar stations can cause interference with and/or damage this
product.
This equipment complies with FCC/IC radiation exposure limits set forth
for an uncontrolled
environment and meets the FCC radio frequency (RF)
Exposure Guidelines in Supplement C
to
OET65
and RSS-1 02
of
the IC
radio frequency (RF) Exposure rules. This equipment has very
low levels
of
RF energy that it deemed to comply without maximum permissive
exposure evaluation (MPE). But it is desirable that it should be installed
and operated keeping the radiator
at
least 20cm or more away from
person's body
(excluding
extremities: hands, wrists, feet and ankles).
THE
FOLLOWING APPLIES ONLY IN
THE U.S.A.
FCC
Note:
This equipment has been tested and found to comply with the limits for a
Class
B digital device, pursuant to Part 15
of
the FCC Rules. These limits
are designed
to
provide reasonable protection against harmful
interference in a residential
installation.
This equipment generates, uses
and can radiate radio frequency energy and,
if
not
installed
and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference
will
not occur
in
a
particular
installation.
If
this equipment does cause harmful interference
to radio
or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged
to
try to correct the
interference
by
one
or
more
of
the
following
measures:
•
Reorient or relocate the receiving antenna.
• Increase
the separation between the equipment and receiver.
• Connect the equipment into an outlet
on a circuit different from that to
which the receiver is connected.
• Consult
the dealer
or
an experienced radio/TV technician for help.
FCC caution:
To
maintain compliance with FCC regulations, shielded
interface cables must be used with this equipment. Operation with
non-approved equipment or unshielded cables may result in interference
to radio and TV reception. Any changes or modifications not approved by
the party responsible for compliance could void the user's authority to
operate this equipment.
This device complies with Part 15
of
the FCC Rules. Operation is subject
to
the
following
two conditions:
(1) This device may not cause harmful
interference, and
(2) this device must accept
any
interference received,
including
interference that may cause undesired operation.
Responsible Party:
Panasonic Corporation
of
North America
One
Panasonic Way
Secaucus,
NJ
07094
Support Contact:
Panasonic Consumer Electronics Company
Telephone No.: 1-800-211-PANA (7262)
THE
FOLLOWING APPLIES ONLY
IN
CANADA.
This
Class
B digital apparatus complies with Canadian ICES-003.
VQT3B58
11