Recording
SQT1111
22
Recording
TV programmes
• If a timer recording reaches its start time when all tuners
are being used for recording, the recording (OTR) of one of
the programmes terminates.
• Teletext will not be recorded.
• Following contents or media cannot be played back while
recording.
- 3D video
- video file
- photo
- USB HDD (For data files, > 16) and USB memory
• Copying cannot be performed while recording.
• When “Automatic Standby after OTR” is set to “On” (> 65),
this unit is turned to standby mode if this unit is not
operated for approximately 5 minutes after completing
“Automatic Stop” or “Recording Time”.
1 Select “Recording Time” or “Continuous
recording” in step 3 (> above).
Recording Time:
You can set the length of recording time from
30 minutes to 4 hours.
• You can select the recording time with [
2
,
1
].
2 Press [OK].
This unit will record the programmes in DR mode
once, and then automatically convert to the
selected recording mode while this unit is in
standby.
1 Press [OPTION].
2 Select “Recording Mode”.
3 Select the recording mode, then press [OK].
• Recording mode (Conversion) (> 16)
• The recording mode set here is used as an
initial value for the next recording.
To convert the recording mode after recording
in DR mode (> 37, File Conversion)
To confirm whether the conversion is
completed (> 38)
To cancel a conversion (> 38)
• The title before conversion (the title recorded in DR mode)
will be deleted once the conversion is completed.
• Conversion will take about the same time as the recorded
duration.
• When the HDD does not have enough remaining space,
conversion will not start.
• Conversion is stopped when this unit is turned on.
Conversion will start from the beginning again once the unit
is switched to standby mode.
• When converted, audio content, subtitle and Audio
Description [For_New_Zealand] will be converted with the
same settings as at the start of recording.
• This unit can record two programmes being
broadcasted at the same time.
Preparation
If you want to change the recording mode (
>
right)
1 Select the channel to record.
2 Press [REC ¥].
Recording will start.
3
Select “Automatic Stop”, then press [OK].
• One touch recording (OTR)
Recording stops automatically when the
programme ends.
To set the recording time
Automatic Stop at XXXXXX
REC1/OTR
Recording Time
Continuous recording
30 min
XXXXXX - XXXXXX
e.g., [For_A us t ra lia]
To change the recording (conversion) mode
HG
HX
HE
HL
HM
XP
SP
LP
EP
Off (DR)
Recording Mode ( Conversion )
OK
RETURN
HDD Remain (DR)m
h
High
Definition
Data Size
Large
Small
Large
Small
Standard
Definition
DMRBWT460GN_eng.book 22 ページ ２０１６年４月１４日 木曜日 午後１２時３分
To Next Page
Loading...
