10
3.1.3.2. Settings for USB-HDD
Delete all titles
Delete all titles on the USB-HDD.
- Delete does not work if one or more titles are protected.
1. Press [FUNCTION MENU].
2. Select "Setup" in "Others", then press [OK].
3. Select "Settings for USB-HDD" in "HDD/ Disc/ USB-HDD", then press [OK].
4. Select "USB-HDD Management", then press and hold [OK] for 3 seconds.
5. Select "Delete all titles", then press [OK].
6. Select "Yes" and press [OK].
7. Select "Start" and press [OK].
8. The confirmation screen appears.
Press [OK].
Format USB-HDD
Formatting deletes all contents, and they cannot be restored.
Check carefully before proceeding.
1. Press [FUNCTION MENU].
2. Select "Setup" in "Others", then press [OK].
3. Select "Settings for USB-HDD" in "HDD/ Disc/ USB-HDD", then press [OK].
4. Select "USB-HDD Management", then press and hold [OK] for 3 seconds.
5. Select "Format USB-HDD", then press [OK].
6. Select "Yes" and press [OK].
7. Select "Start" and press [OK]. Then formatting starts.
8. Press [OK] after formatting completed.
3.1.3.3. To cancell all USB-HDD registrations
• If you register a USB-HDD, all the content already recorded on the USB-HDD will be deleted.
• It is not possible to play back the content on the USB-HDD whose registration has been cancelled.
• You can check the registration number of the USB-HDD on the DIRECT NAVIGATOR.
Cancellation of all USB-HDD Registrations
This function cancells the registrations of all the USB-HDDs registered on this unit.
Only do this if you are going to dispose of this unit.
- Before operation, perform "3.1.2. Disconnecting the USB-HDD" and remove the USB-HDD.
- It is not possible to play back the content from a USB-HDD whose registration has been cancelled.
1. Press [FUNCTION MENU].
2. Select "Setup" in "Others", then press [OK].
3. Select "Settings for USB-HDD" in "HDD/ Disc/ USB-HDD", then press [OK].
4. Select "Cancellation of all USB-HDD Registrations", then press and hold [OK] for 3 seconds.
5. Select "Yes", then press [OK].
6. The confirmation screen appears.
Select "Yes", and press [OK].
7. When the cancellation is complete, message screen appears.
Press [OK].
3.1.3.4. Registration procedure for USB-HDD for inspection
This function registers a USB-HDD for inspection aside from 8 USB-HDDs that can be registered in Normal mode.
If the USB-HDD for inspection is registered in User mode, it cannot be erased. Make sure to use Special mode to register the USB-
HDD for inspection.
Registration procedure
1. Perform "3.4.3. Nondisclosure mode 2" to enter the Service mode.
2. Press the [7][4] buttons of remote control in the Service mode to enter the Special mode.
3. If the new USB-HDD is connected, it is automatically formatted/registered. (There is no TV monitor display for registration.)
The USB-HDD registered in the Special mode can be operated using the same functions (format, record/play/edit, dubbing)
as those for USB-HDDs registered in the Normal mode.
The Special mode can be cancelled at power "OFF" only. (Cancelling the Special mode will erase the registration in the
Special mode.)
To Next Page
Loading...
