11
3.1.4. Operation check when USB HDD is connected
Check the operation status (normal or abnormal) of the USB connection part as follows.
1. Press [FUNCTION MENU].
2. Select "Setup" in "Others", then press [OK].
3. Select "Settings for USB-HDD" in "HDD/ Disc/ USB-HDD", then press [OK].
4. Select "USB-HDD Registration", then press [OK].
Normal operation:
The registered USB-HDD is automatically displayed when connected.
(*Displayed items differ depending on the connected USB-HDD.))
Abnormal operation (1):
When the USB-HDD cannot be detected, "Cannot detect USB HDD." etc. will be automatically displayed.
(*When the cable (USB cable) between the main unit and the USB-HDD is poorly connected (cable disconnection), etc.)
Abnormal operation (2):
When a wrong USB-HDD incompatible with this unit is connected, "Connected USB device cannot be used with this unit.", etc.
will be automatically displayed.
(*Incompatible USB-HDD: When devices with capacity of less than 160GB or more than 2TB or other USB devices are
connected)
Abnormal operation (3):
When more than 1 USB-HDD are connected at the same time, "Registration of USB HDD must be done with only one USB
storage device connected.", etc. will be automatically displayed.
Abnormal operation (4):
When a USB-HDD compatible only with USB 1.1 or below is connected, "Connected USB device cannot be used with this unit.",
etc. will be automatically displayed.
To Next Page
Loading...
