63
9.1.5.2. How to assemble Door Panel Unit
1. Install the Door Panel Unit as follows:
• Insert the Groove of Door Panel Unit to the Shaft of
Front Panel Unit.
• Insert the Hole of Door Panel Unit into the Shaft of
Front Panel Unit.
• Insert the Groove of Door Panel Unit into the Shaft
of Front Panel Unit.
• Insert the Hole of Door Panel Unit into the Shaft of
Front Panel Unit.
• Be careful not to damage the Fulcrum part of the Door
Panel Unit when inserting the Door Panel Unit.
2. Install the 2 Door Springs as shown in the figure.
3. Install the Door Stopper with 1 Screw (A).
9.1.5.3. How to apply Hanarl to the Door
Panel Unit
• Hanarl application locations for the Door Panel Unit.
• Hanarl is not applied to replacement parts.
• Apply adequate of the Hanarl to the designed locations
(RFKXGUD24)
• Apply the Hanarl thinly using a toothpick.
To Next Page
Loading...
