Getting started
SQT0291
13
• While writing to/reading from the media, do not switch the
unit to standby mode or remove the media. Such action
may result in loss of the media contents.
• When inserting the media, ensure that it is facing the right
way up.
1 SD card slot indicator
2 Copying indicator
3 Disc indicator
4 Drive (HDD, BD or SD) indicator
5 Remote control signal indicator
6 Main display section indicator
- Current time
- Playback counter
- Various messages (> 103)
7 Playback indicator
8 USB port indicator
9 Timer recording indicator
• This indicator lights up when the timer
recording standby or Keyword Recording
standby is activated.
Main unit
1 Recording indicator
• The indicator will light up while recording.
• The indicator will blink while recording is
paused and before recording starts.
2 Remote control signal sensor
• Angle: Approx. 20° up and down, 30° left and
right
• Distance: Within approx. 7 m in front of the
unit
3 Open/close disc tray
4 Standby/on switch (Í/I)
Press to switch the unit from on to standby
mode or vice versa. In standby mode, the unit
is still consuming a small amount of power.
5 Disc tray
6 USB port
7 SD card slot
• When removing the SD card, press on the
centre of the card and pull it straight out.
Pull to flip down
the front panel.
Display
Display
PLAY
COPY
SD USB
HDDSD
BD
123
45
6789
DMRBWT945GL_eng.book 13 ページ ２０１４年７月１８日 金曜日 午前１１時３１分
To Next Page
Loading...
