6
RQT6920
Setting up
STEP 2 The remote control
≥Insert so the poles (i and j) match those in the remote control.
≥Do not use rechargeable type batteries.
Do not:
≥mix old and new batteries.
≥use different types at the same time.
≥heat or expose to flame.
≥take apart or short circuit.
≥attempt to recharge alkaline or manganese batteries.
≥use batteries if the covering has been peeled off.
Mishandling of batteries can cause electrolyte leakage which can
damage items the fluid contacts and may cause a fire.
Remove if the remote control is not going to be used for a long
period of time. Store in a cool, dark place.
[Note]
If you cannot operate the unit or television using the remote control
after changing the batteries, please re-enter the codes
(television➜page 10, main unit ➜page 45).
After plugging the unit into your household AC outlet and pressing
[Í, DVD POWER] to turn the unit on for the first time, the unit
assists you to set the menu language, and automatically tunes in all
the channels it can receive and sets the clock.
The unit automatically determines the type of transmission (air or
cable) and puts them into channels as follows.
Batteries
Use
R6/LR6, AA, UM-3
+
+
-
-
Remote control signal sensor
7 m (23 feet) directly
in front of the unit
30x
30x
20x
20x
Band Channel
TV Mode
(Air)
VHF 2s13
UHF 14s69
CATV Mode
(Cable)
VHF 2s13
CATV LOW BAND 95s99
CATV MID/SUPER BAND 14s36
CATV HYPER BAND 37s65
ULTRA BAND
66s94
100s125
SPECIAL CATV CHANNEL 1
To Next Page
Loading...
