Panasonic DMR-EZ27

1 Firmware History
1.1 Applicable Models
DMR-EZ27
Includes models with suffix K or S
1.2 Purpose
U8-225
• Improved playback DVD+R media which was recorded by SONY DVD Recorder.
• Optimization of track jump control for CD-RW.
• Improvement of recording quality for DVD-R DL.
U8-217
• Enhances Closed Captioning display.
• Enables the unit to the download the New V-Chip/Regional Rating Table (RRT).
U8-201
• ATSC level meter indication improvement with weak signal.
• Stops disc rotation when the [EJECT] button is pressed.
U8-196
• Countermeasure for occurred aging mode by remote control signal.
• Protection for Drive unit fuse blowing due to customer Disc condition.
• Upgrade program for next generation drive.
U8-190
• When recording program of 5.1 ch Audio, the center channel audio is not output.
• The title information of the recorded program is not displayed correctly.
U8-184
• Hang-up sometimes occurs using JPEG of RAM disc on "Direct Navigator".
• "Copying has been stopped" message is displayed on the "Status".
• "oooooo" is indicated continuously on power off after malfunction occurs.
• DVD-Video is played back on indication of "oooooo" after power off using EZ-Sync.
DMR-EZ27 DVD Recorder Firmware Installation Instructions
Page 2 of 8