Getting started
SQT0136
19
1 Turn on the TV, then select the appropriate
AV input to suit the connections to this unit.
2 Press [Í] on the remote control or [Í/I] on
this unit.
• The Easy Setting will start at the initial power on.
3 Follow the on-screen instructions and
perform the settings.
• When the Download from TV screen appears, the
setting information on the TV is acquired by this unit.
(> 61)
Auto Setup starts.
(This operation may take some time.)
e.g.,
4 Clock will be set automatically.
If the clock setting screen appears, set the
time manually (> 74, Clock).
5 Set “Quick Start” to “On”, “Off” or “Timer
Setting for Quick Start”, then press [OK].
For details, refer to “Quick Start”. (> 73)
6 If the TV aspect setting screen appeares:
Select the item to match the type of TV
connected.
For details, refer to “TV Aspect”. (> 70)
When “Easy Setting has been completed.”
appears, Easy Setting is complete.
• Select “Yes” to set network settings.
• Select “No” to finish the Easy Setting.
To stop partway
Press [RETURN ].
To restart setup
1 Press [SETUP]. (> 18)
2 Select “Auto Setup” in “Digital TV Tuning”,
then press [OK].
3 Select “Yes”, then press [OK].
• If tuning is cancelled partway through, it may not be
possible to receive the channels. Restart setup again.
Easy Setting
Progress
Digital TV Auto Tuning
CH 6 69
RF Ch
Digital TV: 2
Searching
Quality
Type
Channel Name
This will take about 3 minutes.
35
10
10
35
Digital TV
Digital TV
DMRPWT540GL_eng.book 19 ページ ２０１４年２月６日 木曜日 午前１１時２８分
To Next Page
Loading...
