Panasonic DMR-PWT540 - Copying video; Copying titles

Copying video
SQT0136
43
Copying titles
Copying video
To register the external HDD (USB HDD)
Refer to “Registering the USB HDD”. (> 60)
1 Select “No”, then press [OK] in step 6 (> left).
2 Select the title, then press the yellow button.
Repeat this step to select titles.
3 Go to step 5 (> left).
About screen icons on the DIRECT
NAVIGATOR
Refer to “Screen icons”. (> 33)
1 Select the item in step 7 (> above).
2 Press [2, 1] to change the settings.
• Automatic Standby after Copy
On:
This unit is turned to standby mode when it is
not operated for approximately 5 minutes
after completing copy.
§
§
“For recorded titles (> 9)” only
• The title in the source media will be deleted.
• The recording mode cannot be changed.
1 Connect the USB HDD.
2 Press [FUNCTION MENU].
3 Select “Video” in “Contents on HDD”,
then press [OK].
4 Select the title, then press the yellow
button.
A check mark is displayed. Repeat this
step.
• Press the yellow button again to cancel.
5 Press the blue button.
6 Select “Yes”, then press [OK].
• If you select “No”, you can change the
selection. (> right, To change the
selection)
Start Time
Prog.Type:
Rec time
Channel Date Title Name
Movies
9:00 AM
7 Set other settings, then press [OK].
e.g.,
(> below, Setting the copying options)
8 Select “Yes”, then press [OK].
To change the selection
Setting the copying options
Standby status can be changed if required.
Please press OK to start copying.
OK
RETURN
Automatic Standby after Copy Off
DMRPWT540GL_eng.book 43 ページ ２０１４年２月６日 木曜日 午前１１時２８分