Troubleshooting
VQT2J70
93
Picture regularly breaks up on some
channels.
¾ Adjust the aerial reception with “Manual Tuning”. (> 75)
Picture very infrequently breaks up on some
or all channels.
¾ Electrical atmospheric interference caused by local or
distant lightning storms or heavy rain with wind in “leafy”
locations may cause pictures to break up and audio to
mute or distort momentarily.
After the Easy setting, there are channels
that cannot be seen.
¾ The Easy setting was started and interrupted.
Do an Easy setting again. (> 75)
VIERA Link doesn’t work.
¾ Some functions may not work depending on the version
of “HDAVI Control” of the connected equipment. This unit
supports “HDAVI Control 5” functions.
¾ If the connection for the equipment connected with HDMI
was changed, or if there was a power failure or the plug
was removed from the household mains socket, “HDAVI
Control” may not work.
In this case, change TV (VIERA) setting for “HDAVI
Control” again.
You cannot access this unit from DLNA
compatible equipment on the network.
¾ Check the network connection and the network settings.
(> 13, 19, 66, 81)
¾ It may not be possible to connect depending on the types
of the equipment or the status of the equipment.
To return all the settings other than the main
ones to the factory preset
¾ Perform “Shipping Condition” or “Default Settings”.
(> 83)
To reset the ratings level settings
¾ While the disc tray is open, press [DRIVE SELECT] to
select the BD drive, then press and hold [¥ REC] and
[1](PLAY/a1.3) on the main unit at the same time for 5
or more seconds.
Broadcast
VIERA Link
Network
To reset this unit
DMRBW880GZ-VQT2J70_eng.book 93 ページ ２０１０年５月２４日 月曜日 午後５時３８分
To Next Page
Loading...
