4
VQT1B10
FCC Note: (U.S. only)
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant
to
Part 15 of the FCC Rules.
These limits are designed
to
provide reasonable protection against
harmful interference
in
a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not
installed and used
in
accordance with the instructions, may cause
harmful interference to radio communications. However, there
is
no
guarantee that interference will not occur
in
a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user
is
encouraged to try to correct the interference
by
one or
more of the following measures:
- Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet
on
a circuit different from that
to
which the receiver is connected.
- Consult the dealer or an experienced radiolTV technician for help.
FCC Caution:
To
assure continued compliance, follow the
attached installation instructions.
Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate
this equipment.
This device complies with Part
15
of the FCC Rules. Operation
is
subject
to
the following two conditions: (1) This device may not cause
harmful interference, and
(2)
this device must accept any interference
received, including interference that may cause undesired operation.
(Canada only)
This Class 8 digital apparatus complies with Canadian ICES-DD3.
To Next Page
Loading...
